21 July 2023 By underratedcollege.com 1

Cisco Certified Network Associate (CCNA) : Part 03

Welcome to your Cisco Certified Network Associate (CCNA) : Part 03

1-) Which Cisco IOS command is used on a Cisco Catalyst 6500 series switch to view the spanning-tree protocol (STP) information for a virtual LAN (VLAN)?

2-) Which Enhanced Interior Gateway Routing Protocol (EIGRP) packet type is used for neighbor discovery?

3-) Which layer in the Open Systems Interconnection (OSI) model enables coding and conversion functions for application layer data?

4-) Which of these applications uses the IMAP protocol to transfer information between a server and a host?

5-) Below is the output of the show ip route command from one of your routers:



What does the value 110 represent in the output?

7-) With the following equipment list, which of the following network scenarios could be supported?

– Two IP subnets of 255.255.255.0
– Seven 48-port switches
– Two router interfaces

😎 Which of the following is NOT a true statement regarding Virtual Private Networks (VPNs)?

9-) Which of the following IPV6 commands is used to define a static host name-to-address mapping in the host name cache?

10-) Which two statements are TRUE of synchronous serial ports? (Choose two.)

11-) Refer to the following sample output:



Which Cisco Internetwork Operating System (IOS) command produces this output?

12-) Which of the following is NOT a VLAN Trunking Protocol (VTP) mode of operation?

13-) A host is powered up, but the connected switch port does not turn amber or green.

Which of the following methods would you use to troubleshoot the situation? (Choose three. Each answer is a complete solution.)

14-) Which of the following commands will enable a global IPv6 address based on the Modified EUI-64 format interface ID?

15-) Which of the following commands is used to verify the link-local, global unicast, and multicast addresses of an IPv6 router?

16-) Which type of Category 5 unshielded twisted-pair (UTP) cable is used to work as a trunk between two switches?

17-) A router is running a classful routing protocol. Which command will enable this router to select a default route when routing to an unknown subnet of a network for which it knows the major network?

18-) Which Cisco IOS command is used to configure encapsulation for a PPP serial link on a Cisco router?

19-) A user in your network is having trouble accessing resources and the Internet. You decide to examine the partial output of the ipconfig/all command on his machine. The output is shown below:



Which of the following statements describes the user’s problem?